Minimum Order Quantity | 1 Unit |
Brand | KRE |
Motor Power | 5.5 kw |
The machine is constructed from quality materials and fully treated for corrosion prevention. It has an arrangement to spray degreasant on the engine surface to loosen grease etc. After a delay it gives a fierce spray of water to clean the engine.
Minimum Order Quantity | 1 Unit |
Brand | KRE |
1. A degreasing chemical is sprayed on the engine by a pressurised spray system. Car waits for a few minutes to loosen the mud and then enters into the washing bay. Certain portions of engine where oil is emulsified, diesel or chemical will have to be applied by hand.
2. The vehicle is then driven over the chequered flooring of the Under Chassis wash bay and parked on the designated position.
Engine Wash System
Engine Wash System consists of 14 nozzles. It uses a 5.5 kW pump as standard equipment. Engine wash give a fierce spray of water by fan / jet shaped nozzles fitted on two rows of galvanised pipes. The Engine wash pressure is assisted by air pressure through an air line. The control panel provide for selection of time of its operation from 0 – 6 minutes. 0.37 kW geared motor is used for oscillating the spray system.
Under chassis Wash System
It is envisaged that Standard Under Chassis as being supplied is installed.
The Under Chassis is an assembly of 80 nozzles spread so as to cover the whole under side of a big car. There is provision to work only 60 nozzles, by means of a selector valve (90 degree ball valve) to wash a small car. It uses a 5.5 kW pump as standard Equipment. The under chassis wash give a fierce spray of water by fan / jet shaped nozzles fitted on series of galvanised pipes. The under chassis pressure is assisted by air pressure through an air line. The control panel of under chassis provides for selection of time of its operation from 0- 6 minutes. Auto / manual operation can be selected by selector switch.
After the car is parked on the Under Chassis platform- following is done:-
1. The position of selector valve (90 degree ball valve) is selected for use of 80 nozzles or 60 nozzles depending upon whether a big car or a small car is required to be washed.
2. A 3 way ball valve is provided in under chassis pipe line. In one direction water from 7.5 Hp with air goes to under floor spray assembly.
In the other direction the water outlet is connected to a hand lance. The hand lance should be used to clean the under side of mudguard.
3. After the valve is selected for hand lance position, select the selector switch on the control panel to manual mode & start the under chassis pump to clean the mudguards. All the four mudguards can be cleaned less than 2 minutes.
4. Stop the under chassis water pump, put the 3 way selector valve to under chassis wash positions, select the selector switch in control panel to auto mode and press the green switch for auto operation. The under chassis nozzle will work as per pre-selected time and then stop automatically.
5. After a delay (10 sec), the engine wash pump and oscillating motor will start and after preset time it will stop automatically.
6. The bonnet is closed and car is driven away
4.3/5
Rated by 30 Users